weren't new to me, but cutting such on timbers this size (12 to 16 feet long 8"x8" oak) was new. I began with a simple shouldered tenon on one of the beams. I also planed this timber before cutting the joint. I did not continue to do this on subsequent timbers. My routine developed over time in which planing was the last step. Also, because of the time involved, I planed each timber only on the faces that would be visible in the completed house, and I only planed for smoothness without removing all of the saw marks. This saved time and leaves some of the rustic feel of rough-cut timbers. Initially, my planing was done with a hand plane. I then purchased a cheap electric planer to use. On a large number of the timbers, I preferred the hand plane over the electric planer.
As I progressed on the first beam, I decided to cut a brace in order to test the brace mortises. I designed fully shouldered braces throughout the frame. They are all identical two foot (horizontally and vertically from the intersection of the post and beam) braces cut from 4"x6" oak.
My design also included four scarf joints for the tie beams. Each scarfed beam has a 14' leg and a 12' leg. I was slightly intimidated by cutting the scarf joint, so I decided to tackle it early on. I don't remember how much time I spent on the four sets, but I was pleased with how they came out in terms of fit and overall dimensions on the tie beams.
That's my younger son sitting on the beam "helping" me. I began working on the beams outside near where I had them stacked, as can be seen in the photos. I later cleared out my garage in order to work on them inside. It was much nicer being out of the hot sun in the summer and the cold in the winter. Even though I cleaned out the space to work in, it still accumulates a lot of stuff and mess, not all associated with timber framing.
